Punch Pins

Overview  |  Specifications  |  Application Equipment

Fasten to Sheet Metal... without drilling

Now you can fasten light loads to sheet metal in less time than it takes to drill a hole. This simple, quick fastener is perfect for attaching nameplates, wiring clips and small components to metal doors, electrical cabinets, steel tubing, etc.

Simple application.
Position the Punch-Pin on the tip of the tool, push the tool against the base metal and pull the trigger. The Punch-Pin is driven in a single impact. The fastening is fast and permanent.

No surface preparation.
The hardened steel fastener drives through dirt, oil, grease and most paints. Specially shaped, annular grooves bite into the softer base metal and form a permanent attachment which holds up to 250 pounds. No cleaning, no drilling.

No alignment problems.
A Punch Pin makes its own hole in the base metal so there is never a problem aligning attachment holes with base metal holes.

A Heavy-Duty Solution to Light-Load Fastening
Metal-Tacks eliminate costly problems associated with other fastening methods. Adhesives are messy and may be less than permanent. Other fasteners that require drilled holes also require perfect alignment between base metal and attachment. In addition, drilling holes may cause damage by drilling too deep, and metal drill chips are difficult to completely clean up.

Ordering Information

Part Numbers: 

Punch-Pin #6140
Air Hammer #221
Magnetic Driver #226

Packaging:

1,000 Punch-Pins per vial.

Shipping:

UPS ground unless otherwise specified.

Please call Amtak customer service with any questions.